cisco wap4410n設置方法
cisco wap4410n 這臺AP屬于思科小型企業使用(small business ),企業化功能在同級別產品里還是很強大的,安全也做得不錯,1000M無線接入點還是比較誘人的。那么cisco wap4410n 怎么設置?學習啦小編整理了相關資料,供大家參考。
第一步:如圖設置每個AP的IP地址、網關、DNS
向左轉|向右轉
第二步:設置Basic Wireless,模式B/G/N-Mixed
中繼模式兩端頻道設置成一樣(Wireless Channel一樣)
SSID1:兩臺名稱設置成一樣,其他默認配置
向左轉|向右轉
第三步:Security Mode 兩臺設備選擇一樣加密方式,密鑰也設置成一樣
向左轉|向右轉
第四步: AP Mode主AP選擇Access Point模式,綁定MAC綁定從AP的MAC地址,
allow wireless signal to be repeated by a repeater 打勾,
插上網線,從AP選擇Wireless WDS Repeater模式,
綁定主AP的MAC地址(Site Survey獲取對端MAC),不插網線直接通過主AP連接網絡
向左轉|向右轉
設備系統升級:
如果設備更改配置后依然會在某時間段內重復出現信號衰弱重啟后恢復現象,
建議升級到最新系統,操作部件如下:
步驟一:通過PC網線連接AP,在PC上準備最新系統軟件,點開Firmware Upagrade選項,在FILE對話框中引入系統軟件,選擇Upgrade
按鈕升級系統軟件,中間操作不可中斷造成系統損壞。
向左轉|向右轉
更改配置后可以,YES選項保存更改配置并重啟
向左轉|向右轉
Enter the LAN IP address of the access point (by default:http://192.168.1.245) in the address bar of your internet browser. You will see a window similar to this: Step 2: Type the username and password for the device, which is by default 'admin'. Step 3: Once you have logged in to the web utility of the device, you may start with the configuration of the Access Point. Note:If in case the default IP (http://192.168.1.245) did not work the first time, we advise you to do a hard reset on the WAP4410N by pressing and holding down the reset button for 10 - 15 seconds to set the device back to default settings.Use the screenshot for guide. |
以上就是小編為大家?guī)淼腸isco wap4410n 設置教程方法介紹,都是些簡單的配置,適合新手學習,希望可以幫到大家哦!